Fibro or Asbestos Roof
Preparation work
Preparation is very important when painting your fibro or asbestos roof! First of all you will have to remove all down pipes. Next, you will need to clean down your roof with Mouldshield C diluted 5:1 with water, apply with a soft broom and wash off with hose water, do not use a pressure washer. Caution: By law Fibro or Asbestos roofs are not to be water blasted or cleaned excessively. Refix loose sheets with roofing screws. Repair any minor cracks and holes with Shieldcoat's Roofbond Flexible Pointing.
Preparation is very important when painting your fibro or asbestos roof!
Preparation coatings
If the valleys are lightly rusted, wire brush them down and apply a coat of Rustshield W. If they are heavily rusted then you will need to apply Rustseal and allow at least 24 hours drying time before applying your sealer coat. Apply a coat of Shieldseal W plus to the whole fibro or asbestos roof. If the condition of the roof is poor then you can apply one coat of Fillabond which will help to encapsulate all fibres to produce a better sheen level on top coat.
Finish coatings
Next, apply your two finish coats of ROOFBond Roofing paint to your fibro or asbestos roof, the colour of your choice.
Important Information
Remember, roof safety is very important and often overlooked by inexperience tradesmen or DIY. When doing roof restoration work and it is advisable to wear a respirator and use fall arrest equipment (safety harness/scaffolding).
Final word
After 7 days you can re fit the down pipes and the water you collect is safe for drinking.
For more job specific guides visit our pages on roof paint, concrete paint and heat reflective paint.
Fibro or Asbestos Roof F.A.Q.
Q: Can ROOFBOND roofing paint be applied by brush or roller or does it have to be sprayed?
A: The manufacturer would not recommend rolling or brushing on product, as you may disturb asbestos fibres. See below for our link to our spray guns.
Spraychief Airless Spray Guns
Q: What kind of coverage will I get out of 15lts of Mouldshield C on a my roof?
A: It is difficult to give a coverage rate on 15lt of Moulshield c because it can be diluted between 5:1 up to 20:1 depending on strength needed and again how its applied; sprayed, watering can or broom. Generally one 15lt is enough for a 3 bedroom house roof, leaving you with enough left over to do your bit of cleaning around the home.
Related Products
$188.16USD
NanoProtect SC-96 Clear Protective Coating
$134.40USD
MOULDSHIELD C Mould and Grease Cleaner
$124.80USD
SHIELDSEAL W Plus Water based penetrating sealer
$131.20USD
FILLABOND High Build Acrylic Filler
$126.66USD
ROOFBOND Roofing paint (Clear Glaze)
$140.80USD
ROOFBOND Roof Paint (All Colours) - Durable Roofing Paint
$181.12USD
THERMOBOND Heat Reflective Paint